Dental Separator Material for 3D Printed Models

Introducing our avant-garde dental separator material that enables you to perfectly isolate your 3D printed resin models for casting false gums of RPD or complete denture. Our separator, called "ISOL TEETH™", is available in four colors: transparent, blue, pink, and purple.

Benefits:

• Affordable, efficient, and fast
• Suitable for all laboratory materials, including 3D resins, PEEK (to protect visible parts of frames during polymerization of monomer resins), and PLA for orthodontic laboratories and powder technique
• Non-greasy, leaving no residue or staining on models, RPD, or brushes, and easy to clean after application
• Reduces lines in 3D printed models to achieve a smooth full denture
• Quick and easy to apply, becoming the fastest in its category if drying is expedited with an air gun or torch (a few seconds)
• Transportable by air, and its safety declaration sheet contains no danger pictograms.

RETAIL PRICE: $49

Instructions:

1. Wait until the 3D model is cold before removing the RPD or complete denture.
2. Clean the brush with water after use.

3d model separator, 3D printed model separator

Size: 3.38 oz (100 ml)

Order now and achieve the smoothest results for your 3D printed models.

REF ISOL100E

MANUAL:

- Turn "ISOL TEETH" several times to mix it well.

- It is recommended to work with solid models.

- Hollow models are deformable when heated and permeable to pressure.

- Ensure proper photopolymerization of the models.

- Test the product by pouring resin into the palate of a tall model to understand the principle.

- Use a cold auto resin (such as Pro Base Cold by IVOCLAR), so do not exceed a water temperature of 50 degrees Celsius.

- Wait for the resin to form a thin surface skin before placing it in the water for polymerization.

- Maximum pressure should be 1.2 bars.

- Wait for the model to cool before removing the polymerized prosthesis.

- Clean the intrados (lower part) under water.

- Clean the brush with water.

Fast usage and enjoyable application, it becomes the fastest in its category if you accelerate drying with an air gun or a torch (a few seconds).

It is recommended to isolate the 3D models twice to achieve a smooth and glossy intrados. It may remain slightly sticky to optimize the accuracy of monomer resins during polymerization and obtain perfectly fitting prostheses.